A123 2S1P 6.6V 2300mAh LIFEPO4 Battery Pack
Capacity (mAh): 2300
Dimensions (mm): 70x55x31
Balance Plug: Yes
Balance Plug Type: PolyQuest
Continuous Discharge (C): 30.0C
Continuous Current (A): 69.0A
Burst Discharge (C):60.0C
Burst Current (A): 138.0A
Maximum Charge Rate (C): 4.3C
Maximum Charge Rate (A): 10.0A
Discharge Plug: Yes
Weight: 163g (5.7oz.)
A123-26650-2S1P-A (craft )
Genuine 2-cell 6.6V A123 (LiFePO4) pack, with JST-XH balance tap
and female Deans Ultra plug. Made by A123 Systems from Genuine A123
Fast charge is possible using the appropriate charger. Please do
not attempt to fast charge A123 battery packs using the balance tap
alone, as the balancing
wires are not suitable for high-currents.
These packs make great fast-charge receiver batteries however,
please check whether your receiver and servo; will require a
voltage regulator before using
this pack for this purpose.
Two packs can be joined in parallel to create a 4600mah 2s2p pack.
Use the Deans Parallel Discharge Cable for this purpose and balance
each pack separately.
Alternatively, we also offer a 4600mAh 2S2P pack with the same
Please note, if intending to swap the Deans Ultra plug on this pack
for another type of connector, please remove the plug by cutting
one wire at a time, to
avoid shorting the pack. Or de-solder the existing Deans Plug
carefully after cutting the heat-shrink. We do not recommend
removing or attempting to re-wire
the balance plug.
Nominal pack voltage: 6.6V (3.3V per cell)
Fully-charged pack voltage: 7.2V (3.6V per cell)
Recommended cut-off voltage: 5V (2.5V per cell)
Minimum voltage: 4.0V (2.0V per cell)
Do not charge above 7.2V